Introduction
Subgroups allow us to group similar sounds into a single signal in order to keep consistency when mixing a large number of sounds. For example, drums.
Steps
- Load and set signal levels on a channel
- Assign channel to group 1
- Raise bus master trim 1
- Raise group faders 1
- Assign to Mix
Group Assign
Bus Master Trims
Subgroup Faderss
Subgroup Meters
Channel Group Assign
There are 8 mono groups and 1 stereo group which is actually the main mix bus. By default, the groups are POST fader.
Group Masters
There are a number of controls available to each group. Each group has buttons to assign the group to the left and/or right main stereo mix independently. Like the channels, there is a button to engage or disengage the Pan.
Subgroup Faders
The first 6 group busses have dedicated faders for mixing subgroups and could be assigned to the main stereo mix.
External Routing
The subgroups feed the “Group Outputs” on the patchbay.
