Group Busses

You are here:
Estimated reading time: < 1 min

Introduction

Gather a collection of signals onto a single channel to adjust overall processing.

Think of drum mics – there are multiple microphones to capture this instrument. Once desired levels are achieved for the individual microphone channels, each could be sent to a group to adjust the overall levels, on-board EQ or external processors.

Steps to Use

MAGGIE

  1. Route audio into a channel
  2. Raise the input gain
  3. Raise the channel fader
  4. Assign channel to “1-2”
  5. Raise fader for groups “1-2”
  6. Assign Group 1 to “L”
  7. Assign Group 2 to “R”

SZF & AWX

  1. Route audio into a channel
  2. Raise the input gain
  3. Raise the channel fader
  4. Assign track bus to “1”
  5. Raise track bus master “1”
  6. Patch Track Bus through a signal chain or directly onto an open channel
Was this article helpful?
Dislike 1